UNI-T UT602 Especificaciones

www.pce-industrial-needs.com Tursdale Technical Services Ltd Unit N12B Tursdale Business Park Co. Durham DH6 5PG United Kingdom Phone: +44 ( 0 ) 1

[email protected] 10 General Specifications - Fused Protection for Inductance Input Terminal (UT602): 0.315A, 250V, fast typ

[email protected] 11 Remarks: - Overload protection: 250V DC or AC rms at all ranges. - At 20MΩ range, short circuit test lea

[email protected] 12 D. Inductance Test Remarks: - Measure of Inductance: 1H=10^3 mH = 10^8µ. - Overload Protection: 0.315A

[email protected] 13 B. Replacing the Battery Warning To avoid false readings, which could lead to possible electric shock

[email protected] 14 6. Rejoin the battery compartment and the case top, and reinstall the screw. 7. Rejoin the case bott

[email protected] 2Table of contents Overview ...

[email protected] 3 Overview This Operating Manual covers information on safety and cautions. Please read the relevant inform

[email protected] 4 - Disconnect circuit power and discharge all high-voltage capacitors before testing resistance, continui

[email protected] 51. LCD Display 2. Data Hold (UT602) or L-C switch (UT603) 3. Transistor Jack 4. Resistance, Diode and Conti

[email protected] 6 Measurement Operation - Make sure the low Battery Display is not on, otherwise false readings may

[email protected] 7 3. Connect the test clips across with the object being measured. The measured value shows on the display.

[email protected] 8To test for continuity, connect the Meter as below: 1. Insert the red test clip into the Ω terminal and

[email protected] 9 D. Inductance Measurement To test the inductance, please follow the following procedure: 1. Set the rot