UNI-T UT50C Especificaciones descargar pdf (Pagina 21)

1. According to the size of the tested object’s leads,

insert multi-purpose socket or test clip into the mA

and V terminal.

2. Set the rotary switch to an appropriate measurement

position in HLx range.

3. Insert the tested object into the corresponding jack

of the multi-purpose socket or connect the test clip

to the object being measured.

The measured value shows on the display.

Measurement Operation(9)

l If the value of inductance to be measured is unknown,

use the maximum measurement position, and reduce

the range step by step until a satisfactory reading is

obtained.

l When inductance testing has been completed, remove

the multi-purpose socket or test clip from the input

terminal, and remove multi-purpose socket or test clip

away from the input terminal of the Meter.

( figure 7)

Model UT50D: OPERATING MANUAL

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Renda Boček 22 Jan 2025 | 06:45:39

UNI-T UT50C Especificaciones Pagina 21