UNI-T UT501 Manual de instalación descargar pdf (Pagina 13)

LUMA-NET to MICROPLEX

In this application, Microplex or DMX is mixed with LUMA-NET and transmitted as Microplex.

CONNECTOR OPERATION

Microplex IN Input Microplex

Microplex OUT Retransmitting Microplex (64 or 128)

DMX IN Input DMX 512

DMX out Pass through DMX-512

MIDI / Analog Not used

Luma-net Luma-net network

RS-232 Not Used

JUMPER LOCATIONS

P4 & 5 P7 JP6 & 7 JP8 & 9 JP10 JP11 JP12 JP13

CLOSED CLOSED 2-3 N/A 2-3 2-3 1-2 2-3

P6 P8 JP1 DMX OUT CABLE

*CLOSE TO TERM

DMX

CLOSE TO TERM

LUMA

POSITION 2 JP4

DIPSWITCH POSITIONS

C1 C2 C3 C4 ADDRESS 1 - 7 A8

UP UP UP DN STARTING ADDR OF LUMA-NET IN 16 INCREMENT DN:64

Allows 128 channels of Luma-net to be merged with microplex in a ‘‘last action takes precedence’’ fashion.

Terminate DMX or Luma-net by closing jumper P6 or P8 only if last device on line.

*DMX should only be terminated internally if IF501 will be always last unit at end of DMX line. A better way

to terminate is to connect 120ohm resistor to a female DMX cable end (pins 2-3) and plug it into the pass-through

of the last unit on the DMX line.

See operator’s manual of Luma-net device for additonal information.

Microplex output is sent as either 64 or 128 channels, depending on the setting of switch A8.

INTERFACE UNIT

Software Revision 1.05, Version A LUMA-NET to MICROPLEX

NSI CORPORATION 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Sin comentarios

UNI-T UT501 Manual de instalación Pagina 13